Pink Wallpaper Border

How to Hang Wallpaper Border Like a Professional


If the smooth surface of paint or paint the walls were painted a flat, you will need a primer that covers the surface of the Prime Minister. Use the primer adhere smooth surface, and sealing a flat surface. Starting is important to ensure good adhesion and removal of the border when it comes to roads cleared in time. If you are stopped at the top of the wall on the border of the ceiling, you should measure from the ceiling, 6.3 "short of the border with the same width and draw a pencil line parallel to the upper limit of this measurement. You will be applicable from the pencil line and rear wall paintings on the ceiling making sure to measure the bottom width or border. you may be less than your border displaying the first bait to install.

Wallpapering

The best way (some would say the only way) to install wallpaper border is cut and inserted into the wallpaper border in place.

Suspend your screen as usual, once you reach the end of the wall you will have to install a wallpaper border you go. Position held at the border, and with a new razor blade through the border wallcovering, etc., can be fitted in place on the spot. Lift and remove side wall set the border.

If you have dry and wallpaper and installed, you decide to install a wallpaper border, you must install using the VOV (vinyl stick on the border of wallpaper, vinyl), and not, as described above board industry.

Miscellaneous Tips

In a secret place to start. If the top of the border wall in the ceiling above the door, you enter a corner of the room has begun. This will be the starting point and destination, you will get the last one did not, once you have the room. There are gaps, making it less clear that this is a technical paper at another time another topic, but if you do not fit in the corner should not be too obvious.

Border controls. You need a challenge is how to put the border on the ceiling, because you have room for alternatives. The best solution I found to do is to guard the border with lice, so you move at the bottom of how you work on the walls. Hole left by the pins can be smooth and fluid, not a clear line must be installed.